INNOVARROSIGNATURES

Step 5: Pilot, roll out and roll back

Pilot

Start with two or three people who send a lot of external mail and use different devices. Configure the transport rule for them (see Route mail through the relay) and assign them the add-in.

Each pilot user sends a message to an external mailbox and replies to one. Check:

  • The Mail authentication section on your organisation's page in the portal shows OK for every domain.
  • The signature appears under the new text, and above the quoted history in replies.
  • Name, title and phone numbers are correct. Wrong details are fixed in Entra ID (or overridden per user in the portal).
  • Images show (some mail apps ask the recipient to allow images first).
  • The portal dashboard lists the messages as applied (or skipped with signed by Outlook add-in).
  • The message headers contain X-Innovarro-Signature: applied and pass authentication. See Reading message headers.
  • A message from a phone's built-in mail app gets the signature too.

Run the pilot for a few days.

Roll out to everyone

Check the Mail authentication section again first if you are adding users from other domains.

.\Install-InnovarroSignatures.ps1 -AllUsers -ExcludeSenders scanner@contoso.com,noreply@contoso.com

Exclude addresses that must not get a signature: scanners, automated no-reply addresses, payment or invoice mailboxes that customers' systems process automatically.

Then change the add-in deployment to Entire organization (Microsoft 365 admin center → Integrated apps → Innovarro Signatures → Users).

Roll back

One command stops all routing through the relay. Mail flows directly again within a minute or two:

.\Disable-InnovarroSignatures.ps1

Or in the Exchange admin center: Mail flow → Rules → Innovarro Signatures → switch off.

The connectors stay in place, so turning it back on is the same Install-InnovarroSignatures.ps1 command as before. To remove everything, run .\Disable-InnovarroSignatures.ps1 -Remove.

Changing signatures later

Edit the signature in the portal and save. The change applies to the next message, both in the add-in and in the relay. Every save keeps the previous version, which you can restore from the editor.